Until now, I have been using a Cisco Catalyst 2960 switch. But now I'm considering changing it to a D-Link one.
Would you recommend me doing this change? If so, why?
I am using Cisco Catalyst 3560G which was not in use for a while.
When I start the switch, firstly it hangs during boot then I reset it multiple times and then the page (see below) appears on the console but I'm not able to run any command.
Secondly, all ports are not responding: when I check them no ports or led up when I connect it.
What should I do? Does it is related to hardware failure or a firmware issue? Possibly, something else. Please advise!(less)
We are redoing Wi-Fi and the related Ethernet switches to support it. We're moving from Cisco environment and considering Aruba 515, w/CX6400 Cisco Meraki or possibly an on-prem Wi-Fi controller, Arista Mojo, or Extreme Networks ExtremeCloud IQ.